Peerless-av WL-SR560M-200 - Installation User Manual download pdf (Page 17)

17 of 19

ISSUED: 08-24-12 SHEET #: 180-9037-2 10-30-12

Close the top cover of the power module assembly

(BB), making sure that the power adapter cords run

underneath the cable opening as shown below.

Re-install the M5 x 10mm phillips screws.

Install the cable tie anchor (FF) onto the inside

back wall of the power enclosure (BB). Remove the

adhesive backing from the anchor and press into

place in the area shown.

Place the cords inside the cable management sheath

(II) by pushing the cables through the slit in the

sheath. NOTE: The sheath may need to be trimmed

to length before installing cords.

21 22

CABLE

OPENING

M5 x 10mm SCREWS

Plug extension cord (not included) into power adapter.

EXTENSION CORD

Plug the power cord from your display into the triple

tap grounded outlet as shown. Coil up the excess

cord and secure with a cable tie (GG), inserting it

through the cable tie anchor (FF) and around the

coiled cord.

DISPLAY POWER

CORD

TRIPLE TAP

GROUNDED OUTLET

HDMI-OUT

Plug the component cable(s) from your display

(HDMI shown) into the wireless receiver.

COMPONENT

CABLE

1 2 ... 12 13 14 15 16 17 18 19

No comments

Peerless-av WL-SR560M-200 - Installation User Manual Page 17