Peerless-av WL-SR560M-200 - Installation User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 19
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
12 of 19
ISSUED: 08-24-12 SHEET #: 180-9037-2 10-30-12
NOTE: "X" dimensions should be equal.
NOTE: "Y" dimensions should be equal.
Installing Adapter Brackets to Universal Plate
To prevent scratching the screen, set a cloth on a at, level surface that will support the weight of the screen. Place
screen face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs,
base, cover, or screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the
adapter brackets to be attached.
Position adapter brackets (F) over mounting holes on back of screen. Adjust the position of assemblies
(AA and BB) so that they are at least 32" apart. Make sure assemblies (AA and BB) are evenly spaced from the
adapter brackets. Tighten screws (I) to lock position of assemblies (AA and BB).
Select the small, medium, large or extra large screws from the baf ed fastener pack then attach adapter brackets to
screen following gure 13.1.
NOTE: Top and bottom mounting holes must be used for attaching brackets. Verify that all holes are properly
aligned, and then tighten screws using a security allen wrench.
CENTER BRACKETS
VERTICALLY ON BACK
OF SCREEN
X
X
13
Notes:
• The number of fasteners used will vary,
depending upon the type of screen.
• Multi-washers and spacers may not be
used, depending upon the type of screen.
• Use the corresponding hole in the multi-
washer that matches your screw size as
shown.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
MULTI-WASHER
• Tighten screws so adapter brackets are rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
32" Min.
Y Y
BB
AA
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments