Peerless-av HF646-C63 - Installation User Manual download pdf (Page 3)

3 of 7

ISSUED: 10-22-09 SHEET #: 125-9085-2 11-18-09

Installation to Single Wood Stud Wall

Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended. Based

on its edges, draw a vertical line down the stud’s center. Place wall bracket (A) on wall as a template, making sure

that the three mounting holes are over the stud centerline. Level plate, and mark the center of the three holes. Drill

three 5/32" (4 mm) dia. holes 2-1/2" (64 mm) deep. Make sure that the wall plate is level, secure it using three

#14 x 2.5" wood screws (G) as shown in figure 1.2.

Skip to step 2 on page 5.

• Installer must verify that the supporting surface will safely support the combined weight of all attached equipment and

hardware.

• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is

highly recommended.

• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers

are responsible to provide hardware for other types of mounting situations.

WARNING

STUD

1 2 3 4 5 6 7

No comments

Peerless-av HF646-C63 - Installation User Manual Page 3