Peerless-av DST965 - Installation User Manual download pdf (Page 8)

8 of 11

ISSUED: 10-24-11 SHEET #: 125-9260-2 2-1-13

Note: "X" dimensions should be equal.

Installing Adapter Brackets

To prevent scratching the screen, set a cloth on a at, level surface that will support the weight of the screen. Place

screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be attached.

Place adapter brackets (D) on back of screen, align to holes, and center on back of screen as shown below. Attach

the adapter brackets to the back of the screen using the appropriate combination of screws, multi-washers and

spacers as shown in step 8-1 and step 8-2.

NOTE: Top and bottom holes on screen must always be used.

Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.

NOTE: Tighten using security allen wrench (X).

MEDIUM HOLE FOR M5 SCREWS

SMALL HOLE FOR M4 SCREWS

LARGE HOLE FOR M6 SCREWS

CENTER BRACKETS

VERTICALLY ON BACK OF

SCREEN

Notes:

• The number of fasteners used will vary,

depending upon the type of screen.

• Multi-washers and spacers may not be

used, depending upon the type of screen.

• Use the corresponding hole in the multi-

washer that matches your screw size as

shown.

MULTI-WASHER

• Tighten screws so adapter brackets are rmly attached. Do not tighten with excessive force. Overtightening can

cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become

detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly

secured, damage may occur to screen or product may fail.

WARNING

NOTE: For at back screens proceed to step 8-1. For bump-out or recessed back screen skip to step 8-2.

1 2 3 4 5 6 7 8 9 10 11

No comments

Peerless-av DST965 - Installation User Manual Page 8